Sensor _ HALIOS®

The High Ambient Light Independent Optical System (HALIOS®) is based on a compensation principle similar to an optical bridge. The high sensitivity resulting from this enables the detection of gestures (e.g. movement of a finger or hand) without the use of mechanical elements. The integrated circuit (IC) prepares the signals based on optical reflections to objects to be detected and therefore, allows concluding the position of the object in all three directions in space to the sensor.
Part-No./Function Interface FlexRayTM Standard Recommended IMAX Efficiency Output Range Transducer frequency Driver output Memory Detection Sensitivity Bandwidth VBAT VOUT VSUPPLY Protection ISUPPLY IPEAK IMAX DC P(Motor) peak P(Motor)max VDD VER Iq RDSON ESD (kV) Bitrate Cranking Support High-Side Driven Low-Side Driven Bi-Stabil Included µC Feed-Back Inputs Package Status Comment
E527.05
HALIOS® Rain and Light Sensor with LIN

-

-

-

5.0V to 28V 5mA (typical)*, 10µA (sleep)

QFN44L7

  • Logarithmic amplifier for ambient light measurements
  • SPI interface
  • 3.3V Voltage regulator, 100mA output current
  • BUS pin ESD-protected +/- 8kV according to IEC61000-4-2
  • Transceiver compliant with LIN2.1, LIN2.2 and SAE-J2602
  • Two 40mA embedded LED drivers

  • * Without LED current and photo diode current
E527.16
HALIOS® Gesture Switch

Proximity
Awareness

-

-

2.25V to 2.75V 3.3V (periphery) 3.5mA (typical)

QFN32L5

  • Advanced ready-to-use function
  • Implemented gesture recognition
  • PWM-Output for innovative motion-controlled lighting application
E909.06
HALIOS® Multi Purpose Sensor for Automotive

Proximity
1...3 dimensional input devices
Touch

-

-

2.25V to 2.75V, 3.3V (GPIO) 2.5mA (typical), <50µA (stop mode)

QFN32L5

  • Optical/capacitive sensor IC for gesture control and object detection
  • 5 LED drivers, 8x GPIO
  • 16 bit µC with flash
  • SPI-compatible, I2C Interface, LIN UART
  • Internal temp. compensation
  • Standard Firmware implemented
E909.07
Transimpedance Amplifier with High Sensitivity

-

172dBOhm

500kHz

3V to 3.5V 3mA (typical), <1µA (sleep)

QFN20L4
Bare-Die

  • Enlarges detection range of HALIOS® ICs E909.06
  • Limiting amplifier output
  • High resistive output stage
E909.11
Ultra Low Power HALIOS®

Proximity
1...3 dimensional input devices
Ambient Light Measurement

-

-

2.2V to 3.6V 10µA (typical), 4.5µA (idle), 0.4µA (sleep)

QFN20L4
Bare-Die

  • IC for gesture control solutions, proximity and ambient light measurements
  • Adaptive power saving control
  • Self-calibration
  • I2C Interface