The IC drives 2 or 3 unipolar stepper motors and provides an optional stall detection for end position detection. For LED dimming a quasi logarithmic duty cycle is following the physiology of the human eye. With 3 PWM... read more


  • 12 high current outputs (RDSON typ. 1.5Ω / IMAX = 350mA)
  • Low standby current (typically <1μA)
  • Serial interface (SPI) for direct μC interfacing
  • Short circuit / Open load detection, diagnosis
  • Stall detection for full-/half-step, wave drive
  • Stall detection qualification service
  • TJunc peak = +150°C


Document Description Type
Info Sheet PDF 653 kB

Application diagram


  • Stepper Motor Driver with/without Stall Detectio
  • Headlight Adjust
  • HVAC Flaps
  • DC Motor Driver with PWM
  • Relay Driver with VBAT- automatically PWM
  • LED Driver with 3 logarithmic PWM sources

Order Information

Distributor Inventory Search
Buy our Products at your local Distributor
Please note that you are leaving the Elmos website with this link.


Part No. Channels Stall Detection Package Order No.
E520.08 8 - QFN20L5 E52008A62C
E520.08 8 - QFN32L5 E52008A61C
E520.08 8 - SOIC20 E52008A55E


Part No. Function Board type Order No.
also for
12x Low-Side for 3 Stepper Motors with/without Stall Detection Demo- / Evaluation Board K52001-0001
*Plug & PlayChip with defined functionality | no controller programming necessary
*SoCSystem-on-a-Chip | with integrated microcontroller
*SBCSystem-Basic-Chip | with Voltage Regulator Reset, Watchdog, physical Interface
*Driver ICDriver Chip without SBC or SoC features
Cookie-Popup anzeigen