The Elmos System-on-a-Chip (SoC) family E523.3x controls four high-side driven relays, alternatively two of them lowside driven, or three bistable relays (activation in sequential order). The low-side driven relay holding current can be programmed by closed loop current controlled output stages, using a chopper principle. The high-side drivers do not support current control. The IC is controlled over a LIN 2.x(1.3), SAE-J2602 compliant communication interface. It’s node address within the LIN cluster can be determined at run time by using the “auto-addressing” feature (officially referred to as “SNPD” in the LIN specification). Neither a pin address coding or a pre-programming is needed in this case. So this is the optimal solution for following the „equal parts strategy“.
Alternatively the IC can be controlled by a PWM-interface, with diagnosis feedback. The IC core is an 8-bit microcontroller which is assisted by powerful circuitry. For relay diagnosis the IC provides three GPIO ADC input pins. ICs with FLASH memory are programmable via JTAG interface or via LIN boot loader function in normal or high speed mode. The LIN boot loader is placed in SysROM area for max. programming security and reducing the code size of the application program. For fast time-to-market Elmos provides demo-boards as well as design-in support, LIN library routines, demo code and training on the software development tool-chain.
- Controls 4 high side driven relays or 2 low side driven relays or 3 bistable relays
- Programmable holding current for low-side up to 800mA
- 5.5V to 20V supply voltage (load dump 42V)
- Embedded 8bit μC 256 Byte RAM, 8k FLASH + 4k SysROM,
64 Byte E²
- LIN2.x(1.3),SAE-J2602 or PWM Interface, LIN Auto-Addressing
- TJunc peak = +170°C
|Info Sheet||PDF 159 kB|
- LIN 2.x or LIN 1.3 relay nodes
Distributor Inventory Search
Buy our Products at your local Distributor
Please note that you are leaving the Elmos website with this link.
|Part No.||Features||Package||Order No.|
|E523.30||LIN or PWM-interface, |
8k customer FLASH
|E523.31||LIN with firmware (FLASH)||QFN32L6||E52331C77B|
|E523.34||PWM interface |
8k customer FLASH
|E523.37||LIN or PWM with 8k customer FLASH||QFN32L6||E52337C77B|